The best part about an epoxy floor coating is that you can install it yourself without having to hire professionals for the job. Not only do you save on money when you do the epoxy garage floor coating yourself but you get more satisfaction with the finished floor as it your own doing. Most people install epoxy floor coatings in their homes themselves. These floors are good to look at. They don’t require much cleanliness and one swipe of wet cloth is enough to give the floor that spick and span look. They are resistant to oil stain as well as other fluids and have the ability to bead water. Apart from that, with an epoxy floor, you’re garage looks great and gives the feeling of a showroom.
In order to apply an epoxy floor coating on your garage floor, get yourself an installation kit from the nearest hardware store. Theses kits have all the tools and the materials that you would require in order to apply the epoxy concrete floor coating. Before doing anything, you need to make sure that the surface on which the coat will be applied is absolutely dust free. Sweep the floor to remove any dust particles and dirt. Not only do you have to clean the floor from dust but after that, you should apply an etching solution on the floor and scrub thoroughly. Make sure that you wear protective gear like gloves and boots when you are applying the etching solution. Etch the floor in small sections and then rinse it with water. Allow the floor to dry for about three to four hours.
Prepare the epoxy paint by pouring the hardener into it and stirring it. Make sure that you stir the mixture for enough time so that the two components are perfectly mixed. Apply the paint within two hours of its preparation. Use a roller to evenly apply the epoxy coat over the whole floor.. Cover the area section by section to ensure even application of the coat. It entirety depends upon you whether you go for a double coat or not, If you do, let the first coat dry for about 12 hours or even more and then apply the second coat.
Apply the color flakes by taking a handful and spreading them evenly over the wet floor, just as you sprinkle fertilizer in your lawn. You then need to prepare the top coat for application. The hardener is poured into the clear top coat and you have to stir it properly to make sure it is completely mixed. Add antiskid granules if you want to. Then apply the top coat, working section by section. Work the mixture in one direction and then in the perpendicular direction. Let the floor dry and you’re good to go.
Comments on this entry are closed.